Alber GO V2 Instrucciones De Montaje página 13

6. Mount the bracket for the control unit - on a wheelchair with drum brakes
10
• Unscrew the screws from the upper bracket [12] of the brake lever.
• Replace the upper bracket of the brake lever with the bracket of the control unit
11
[12].
12 The bulge of the bracket of the control unit [12] should point forward as seen in
the direction of travel.
• Tighten the screws [10] of the bracket of the control unit [12] with a tightening
13
torque according to the specifications of the wheelchair manufacturer.
7. Mount the bracket for the control unit - on a wheelchair without drum brakes
• Place the upper bracket (the bracket of the control unit [12]), the washers [11]
10
and the screws [10] on the optional counter bracket [14].
The bulge of the bracket of the control unit [12] should point forward as seen in
11
the direction of travel.
• Tighten the screws [10] of the bracket of the control unit [12] with a tightening
12
torque according to the specifications of the wheelchair manufacturer.
14
8. Attach the control unit to the bracket of the control unit
• Hang the via GO V24 control unit [9] from the right as described in the via GO
operating instructions.
• Place the control unit [9] on the bracket of the control unit [12] as described in
the via GO operating instructions.
5