Publicidad
Idiomas disponibles
Idiomas disponibles
Important safety information
Work on the via GO, its individual components and the bracket on the wheelchair may only be carried out by persons who
have been authorized by Alber to carry out this work.
Attention! The via GO has no braking function. Therefore, the wheelchair must be equipped with brakes if the
operators are physically unable to bring the wheelchair to a stop in all driving situations. Ideally, these brakes
are two drum brakes.
Important note
These general assembly instructions inform you about the basic assembly steps to be followed when attaching the
• bracket for the drive unit on a standard or lightweight wheelchair
• bracket for the control unit on wheelchairs with two brake handles for drum brakes
• bracket for the control unit on wheelchairs without drum brakes
1
1. Scope of delivery
• Bracket for the via GO, depending on the seat width according to the order [1-3, 6+7]
• Bracket for the control unit:
- for wheelchairs with two brake handles for drum brakes [12]
- for wheelchairs without drum brakes [12]
- optional counter support for the bracket of the control unit [14] - for wheelchairs without drum brakes
1
2
3
1 Clamp inside
2 Clamp outside
3 Holder
4 Frame tube rear
5 Frame tube bottom
6 Cross bar with locking
7 Push bar
4 5
6
D
8 Drive wheel
9 Control unit
10 Screw
11 Washer
12 Bracket of the control unit
(upper bracket)
13 Bracket of the control unit
(bottom bracket)
14 Support of the control unit (=
optional counter support)
8
7
9
10
11
12
13
9
10
11
12
14
Publicidad
