Publicidad
Idiomas disponibles
Idiomas disponibles
Maintaining the Engine
When transporting a sprayer with a gas engine,
make sure the fuel is shut off.
NOTE: For detailed engine specifications and
maintenance, refer to the separate engine manual
supplied with this sprayer.
Important Facts concerning this Sprayer
This gas-powered sprayer contains a clutch that engages when
the sprayer is pumping. The sprayer's pressure control system
engages and disengages the clutch to control pressure. To
prevent unnecessary wear to the clutch, it is advisable to adjust
the engine speed and pressure setting to limit the amount of
times the clutch engages and disengages. To reduce clutch
wear, refer to the following examples.
Example:
Operating one gun with a .019" tip — reduce the engine speed
by adjusting the throttle to a low or medium setting and increase
pressure only until the heavy ends of the spray pattern have
been eliminated.
Example:
Operating one gun with .025" tip — increase engine speed to a
higher setting and increase pressure until the heavy ends of the
spray pattern have been eliminated.
Example:
Spraying light-bodied materials at low pressure — to reduce
surging at the gun and to decrease clutch wear, reduce the
engine speed to idle and reduce pressure until the desired spray
pattern is achieved.
Routine Engine Maintenance
Daily
• Check and fill the gas tank.
• After the first 20 hours of operation, drain the oil and
refill with clean oil. Check the engine oil level and fill as
necessary.
Weekly
• Remove the cover of the air filter and clean the element.
Replace the element if necessary. If operating in an
unusually dusty environment, check the filter daily and
replace if necessary. (Replacement elements can be
purchased from your local Titan dealer.)
• After each 50 hours of operation: Change the engine oil.
Spark Plug
• Use only a (NKG) BR6HS or Champion RL86C plug.
• Gap the plug 0.020" – 0.030"
• Make sure to use a spark plug wrench when installing and
removing the plug.
English
cleaning or Replacing the Filters
Pump Filter
1. Loosen and remove the filter housing by hand. Pull the
filter out of the pump manifold.
2. Slip the filter off of the filter support spring.
3. Inspect the filter. Based on inspection, clean or replace
the filter.
4. Inspect the filter seal. Based on inspection, clean or
replace the filter seal.
5. Slide the new or cleaned filter over the filter support spring
with the adapter in place. Push the filter into the center of
the pump manifold.
6. Slide the filter housing over the filter and thread it into the
pump manifold until secure.
NOTE: The filter housing should be hand-tightened, but
make sure the filter housing is seated fully into
the pump manifold.
Adapter
Filter Support Spring
Filter Seal
Pump Manifold
Gun Filter
1. Pull the bottom of the trigger
guard forward so that it
comes loose from the handle
assembly.
2. Loosen and remove the handle
assembly from the gun head.
3. Pull the old filter out of the gun
head.
4. Slide the new filter, tapered
end first, into the gun head.
5. Make sure the handle seal is in
position and thread the handle
assembly into the gun head
until secure.
6. Snap the trigger guard back onto the handle assembly.
8
Filter
Housing
Filter
Spring
Filter
Gun
Housing
Filter
Handle
Seal
Handle
© Titan Tool Inc. All rights reserved.
Publicidad
