Festool ETS 150/3 EQ Manual De Instrucciones Original/Lista De Piezas De Repuesto página 9

Eccentric sander
Technical data
Wattage
Speed (220 - 240 V)
Speed (110 V, 120 V)
Sanding stroke
Sanding base
Weight
Degree of protection
The specifi ed illustrations can be found at the beginning of the operating instructions.
Symbols
Warning of general danger
Wear a dust mask!
Wear protective goggles!
Read the Operating Instructions/Notes!
1 Safety instructions
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fi re and/
or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
Always wear protective goggles because
of possible dangers when sanding.
The manufacturer's handling and processing
instructions must be observed without fail if ex-
plosive or self-igniting dusts are likely to occur
during sanding.
Harmful/toxic dusts can occur during your work
(e.g. lead-containing paint, some types of wood
and metal). Contact with these dusts, especially
inhaling them, can represent a hazard for operating
personnel or persons in the vicinity. Comply with
the safety regulations that apply in your country.
Connect the electric power tool to a suitable ex-
traction system.
To protect your health, wear a P2 protective
mask.
ETS 150/3 EQ
ETS 150/3 E
310 W
4,000 - 10,000 rpm
6,000 - 10,500 rpm
3.0 mm
Ø 150 mm
1.8 kg
/ II
2 Correct usage
The sanders are designed for sanding wood, plas-
tic, composite materials, paint / varnish, fi lling
material and similar materials.
Metal and materials with an asbestos content must
not be processed with these tools.
The machines must not be damp nor operated in
a damp environment for electrical safety reasons.
The machines may only be used for dry sanding.
The user bears sole responsibility for any damage
or accidents resulting from incorrect use.
3 Noise and vibration information
Typical values established in compliance with EN
60745:
Sound pressure level
Sound-power level
Measuring uncertainty allowance
Overall vibration levels (vector sum for three direc-
tions) measured in accordance with EN 60745:
Vibration emission level
(3 directions)
Uncertainty
The emission values specifi ed (vibration, noise)
were measured in accordance with the test con-
ditions stipulated in EN 60745 and are intended
for machine comparisons. They are also used for
making preliminary estimates regarding vibration
and noise loads during operation. The emission
values specifi ed refer to the main applications for
which the power tool is used. If the electric power
tool is used for other applications, with other tools
or is not maintained suffi ciently prior to operation,
however, the vibration and noise load may be higher
when the tool is used. Take into account any machi-
ne idling times and downtimes to estimate these
values more accurately for a specifi ed time period.
This may signifi cantly reduce the load during the
machine operating period.
9
ETS 150/5 EQ
ETS 150/5 E
310 W
4,000 - 10,000 rpm
6,000 - 10,500 rpm
5.0 mm
Ø 150 mm
1.8 kg
/ II
72 dB(A)
83 dB(A)
K = 3 dB
a = 5,0 m/s
h
K = 2,0 m/s
2
2