Dräger Flame 3000 Instrucciones De Uso página 9

● Ensure there is maintenance access to the Dräger Flame 3000 (e.g. direct,
ladder or scaffold access).
● Ensure that mounting supports are compatible with the Dräger Flame 3000
mounting brackets.
● Ensure that the Dräger Flame 3000 does not have a direct view of any
sources of flame used during normal operations, such as flare stacks.
● Ensure that the Dräger Flame 3000 is positioned so that it is not directly
facing the sun.
All these issues are of crucial importance to a successful installation, and they
should be given great attention during the detailed design, construction, and
commissioning phases of the work.
Detector coverage
Software analysis of the actual detector field of view may be required to ensure
adequate coverage of the hazards. This analysis can also be used to optimize
the number of detectors and the loop configuration .
Power and cable requirements
The Dräger Flame 3000 requires a supply voltage of 18 – 30 V at the input
terminals.
The installation location and local regulations and standards determine the
cable specification.
The Dräger Flame 3000 contains further details of the power and cable
selection requirements. Contact Dräger for details.
3.2 Installation
WARNING
Do not open the enclosure in an explosive atmosphere as it could lead to an
explosion.
Ensure that the flame path of the Dräger Flame 3000 is not damaged during
installation. A damaged flame path could lead to an explosion.
Do not drill holes in the enclosure as it could lead to an explosion.
Instructions for use |
Dräger Flame 3000
CAUTION
The Dräger Flame 3000 may be damaged by high voltage insulation tests and
other cable testing operations. It should only be installed after these tests are
complete.
Do not drop or knock the enclosure as this may damage the detector assembly.
Only appropriately trained service personnel may open the enclosure. Incorrect
disassembly of the Dräger Flame 3000 may damage the equipment.
NOTICE
Before installing the Dräger Flame 3000, it is advisable to check the mounting
locations to ensure that there have been no changes made during construction
that will affect detector coverage.
3.2.1 Mechanical installation
The mounting bracket allows the vertical orientation of the Dräger Flame 3000
to be adjusted from 0 to 45°, and allows a horizontal rotation of up to 90°.
| en
Use
9