HQ-Power VDPLW800 Manual Del Usuario página 4

4. Installation
a) Fixture
• Choose a suitable mounting location and mount the light in the desired angle.
• Use a waterproof cover when using the light outdoors.
• Insert the power cord into an appropriate outlet (230VAC / 50Hz).
• Switch off the power to the light when not in use.
• This LED light is controlled through a 3-pin XLR (1 = GROUND, 2 = DATA-, 3 = DATA+).
b) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse holder at the back using an appropriate screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder and fasten tight with the screwdriver.
c) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorized persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
• The LCD Menu
Turn the wheel next to the LCD in a clockwise direction to show the menu options in the following sequence:
Addr*** → Manual Blue*** → Manual green*** → Manual red*** → No DMX Auto/Sound/Manual → Chase8 - 1
→ DMX mode 8-group/4-group/2-group/1-group → DMX mode 3-channel/6-channel
Turn the wheel to select and press to enter the settings of the desired menu option.
NOTE: Whenever idle for 3 seconds, the LCD will faint down its background illumination and will display Addr***
when there is DMX connection (*** indicating the present DMX address). When there is no DMX, it will display the
preset non-DMX running mode: auto, sound or manual. When you operate it again, the LCD will return to the last
menu option before idling.
VDPLW800_v2 4 VELLEMAN