Tools Included; Parts Included; Need Help - Vision Fitness T80 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TOOLS INCLUDED:

8 mm T-Wrench
6 mm T-Wrench
5 mm T-Wrench
5 mm L-Wrench
4 mm L-Wrench
13 mm Hex Wrench
Screwdriver

PARTS INCLUDED:

2 Console Masts
2 Handlebars
2 Support Bars
2 Support Bar Caps
2 Sets Base Frame Covers
1 Console Base
1 Console Base Cover
1 Water Bottle Holder
1 Accessory Holder
1 Hardware Kit
1 Safety Key
1 Power Cord

NEED HELP?

If you have questions or if there
are any missing parts, contact
your authorized Vision Fitness
retailer.
PRE-ASSEMBLY
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a
protective covering on your floor. Take CAUTION when handling and transporting this
unit. Once the banding straps have been removed, do not transport this unit unless it is
fully assembled. Unpack and assemble the unit where it will be used. Never grab hold of
any portion of the incline frame and attempt to lift or move the treadmill. Lift the treadmill
from the roller end caps area while a second person removes the parts packed under
the treadmill.
WARNING
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any grease,
such as lithium bike grease, is recommended.
23

Publicidad

Tabla de contenido
loading

Tabla de contenido