Ecoflam MINOR 4 SP 30 Manual Del Usuario página 11

Burner does not start up
Burner pre-purges and stops
Burner does not ignite during cycle and stops
Burner does not ignite
Burner ignites and then stops
FAULT FINDING
- Mains switch not on.
- Blown fuse.
- Boiler thermostats not made.
- Fault in control box.
- Fault in control box.
- Fault in control box.
- Fault in photo-resistor.
- Dirty ignition electrodes.
- Fault at electrodes.
- Electrodes installed wrongly.
- Fault ignition transformer.
- Blocked nozzle.
- Nozzle needs replacing.
- Oil pressure too low.
- Blocked oil filter.
- Excessive combustion air for nozzle capacity.
- Fault in control box.
- Faulty nozzle.
- Photo-resistor does not "see" flame.
- Excessive combustion air for nozzle capacity.
- Fault in control box.
- Oil pressure too low.
- Blocked oil filter.
pag.11
GB
BM2