Listening To The Am/Fm Radio - Onkyo TX-NR474 Manual De Instrucciones

> Before Start > Part Names

Listening To the AM/FM Radio

1
You can receive FM and AM radio stations
on this unit with the built-in tuner. Perform
the following procedure when the unit is on.
∫ Tuning into a Radio Station
Tuning Automatically
1. Repeatedly press TUNER (a) on the
remote controller and select "AM" or
"FM".
2. Press MODE (e) on the remote
controller so that "TunMode:Auto"
appears on the display.
3. When you press the cursor /
(b) on the remote controller, automatic
tuning starts, and searching stops when
a station is found. When tuned into a
radio station, the "TUNED" indicator on
the display lights. When tuned into an
FM radio station, the "FM ST" indicator
> Install
2
lights.
When FM broadcasts reception is poor:
Perform the procedure for "Tuning
Manually" in the following section. Note
that if you tune manually, the reception for
FM broadcasts will be monaural rather than
stereo, irrespective of the sensitivity of the
reception.
Tuning Manually
If you tune manually, the reception for FM
broadcasts will be monaural rather than
stereo, irrespective of the sensitivity of the
reception.
1. Repeatedly press TUNER (a) on the
remote controller and select "AM" or
"FM".
buttons 2. Press MODE (e) on the remote
controller so that "TunMode:Manual"
appears on the display.
> Initial Setup > Playback
3
3. While pressing the cursor
(b) on the remote controller, select the
desired radio station.
0 The frequency changes by 1 step
each time you press
frequency changes continuously if the
button is held down and stops when
the button is released.
Frequency step setting
Press on the remote controller, then use
the cursor buttons and ENTER on the
remote controller to select "6.
Miscellaneous" - "Tuner" - "AM Frequency
Step", and select the frequency step for
your region. Note that when this setting is
changed, all radio presets are deleted.
Advanced Setup | Supplementary Information | Others
/ buttons
a
/ . The
b
c
d
e
29
En