Onkyo TX-NR474 Manual De Instrucciones página 58

> Before Start > Part Names
∫ 3. DTS
DTS Auto Surround When inputting DTS signals that include extended channel
information, the optimum listening mode is automatically
selected according to the extended information contained in the
input signal and the speaker configuration of this unit when
playing in the straight decoding listening mode.
"On (default value)": When this function is to be used
"Off": Audio is played using the same amount of channels in the
input signal according to the speaker configuration of this unit.
∫ 4. LFE Level
Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series, Multichannel
PCM, and DSD signals.
LFE Level Select the low-frequency effect (LFE) level of each type of signal
from "0dB (default value)" to "-¶dB". If the low-frequency effect
sound is too strong, select "-20dB" or "-¶dB".
∫ 5. Volume
Mute Level Set the volume lowered from the listening volume when muting
is on. Select a value from "-¶dB (default value)", "-40dB", and "-
20dB".
Maximum Volume Set the maximum value to avoid too high volume. Select "Off
(default value)" or a value between "50" to "99".
Power On Volume Set the volume level of when the power is turned on. Select
"Last (default value)" (volume level before entering standby
mode), "Min", "1" to "99" and "Max".
0 You cannot set a higher value than that of "Maximum
Volume".
Headphone Level Adjust the output level of the headphones. Select a value
between "-12 dB" and "+12 dB". (Default Value is "0dB")
58
> Install > Initial Setup > Playback
Advanced Setup
4. Source
∫ 1. IntelliVolume
Adjust the volume level difference between the devices connected to the unit. Select the
input selector to configure.
IntelliVolume Select a value between "-12 dB" and "+12 dB". Set a negative
(j) value if the volume of the target device is larger than the
others and a positive (i) value if smaller. To check the audio,
start playback of the connected device. (Default Value is "0dB")
∫ 2. Name Edit
Set an easy name to each input. The set name will be shown on the main unit display. Select
the input selector to configure.
Name Edit 1. Select a character or symbol with the cursors and press
ENTER.
Repeat it to input 10 or less characters.
"A/a": Switches between upper and lower cases. (Pressing
MODE on the remote controller also toggles between upper
and lower cases.)
" " " ": Moves the cursor to the arrow direction.
" ": Removes a character on the left of the cursor.
" ": Enters a space.
0 Pressing CLEAR on the remote controller will remove all
the input characters.
2. After inputting, select "OK" with the cursors and press
ENTER.
The input name will be saved.
0 To name a preset radio station, press TUNER on the remote controller, select AM/FM and
select the preset number.
0 It cannot be set if the "NET" or "BLUETOOTH" input is selected.
∫ Audio Select
Select the priority for input selection when multiple audio sources are connected to one input
selector, such as connections to both the "GAME" HDMI IN jack and the "GAME" AUDIO IN
jack. The setting can be separately set to each input selector. Select the input selector to
| Supplementary Information | Others