Orbegozo CR 5028 Manual De Instrucciones página 14

CR 5028
SAFE POSITIONING
1. The heater must not be located immediately below a socket outlet
2. For your own safety and that of others: water and electricity are a dangerous combination! Do not
use this heater in the immediate surroundings of a bath, a shower or a swimming pool. Ensure that the
appliance cannot fall into water (bath wash basin, shower cubicle, etc.)
3. Please read also the safety information's before using.
4. Do not use the heater on extremely deep-pile carpets!
5. Do not use the heater in an upright position.
OPERATION
When the appliance is switched on for the first time, a slight smell may be emitted. Please ensure
sufficient ventilation. This smell will disappear very quickly.
The heater may be operated by the manual controls located on the Heater (as shown in FIGURE 2).
Carefully remove the Heater from the plastic bag and the carton.
- Place the heater on a firm, level surface.
- Plug the cord set into a 230V~ electrical outlet. When the heater is initially plugged in, the red
light will come on indicating that there is power to the unit. The Heater is ready to use. The red
light will remain lighted until the heater is unplugged from the electrical outlet.
- When selecting position
- Set the selector to position
- When selecting position
temperature when turning the wheel in the clockwise direction.
- To switch off the device, select position
- To make the heater swing to the left and right, press the button on the base of the appliance.
OVERHEATING SAFETY DEVICE
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the
power as soon as the heating elements become too hot.
, the device will emit fresh air.
so that it operates in heat mode at 1000W.
, the device will operate at a maximum of 2000W, regulating the
.
14