LiftMaster 87504-267 Instrucciones De Montaje página 41

Operation
1
2
Press
4
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL USING THE LEARN
BUTTON
1. Press and release the LEARN Button on the garage door opener.
2. Press and hold the button on the remote control that you wish to use. Release the button when the garage
door opener lights blink or two clicks are heard.
1
LEARN LED
3
to continue. Press to continue.
OR
? ? ? ?
PIN
2
LEARN
Button
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6
seconds).
2. Immediately press and hold the LEARN button again until the learn LED goes out. All codes are now
erased. Reprogram any accessory you wish to use.
ERASE THE CAMERA SETTINGS
1. Press and hold black adjustment button on the garage door opener until 3 beeps are heard (approximately
6 seconds). The LED light will turn off, then flash red.
You will need to setup both the garage door opener and camera again after resetting it.
LED
41
LEARN Button
Adjustment Button