Publicidad
Step 11
å
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into
the LEFT END (B) until the shoulders of the SCREWS rest
on the surface of the END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the remaining END MOLDING (M) onto the END (B).
Line up the groove in the MOLDING over the heads of the
SCREWS in the END.
å
NOTE: The MOLDING should be centered on the END.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
Page 16
32S
B
423392
M
Shoulder
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
www.sauder.com/service
Publicidad
