Publicidad
Step 20
1
BROWN 1" FLAT HEAD SCREW
L
K
å
Fasten the DRAWER FRONT (L) to the DRAWER
FRONT MOLDING (K). Use two BROWN 1" FLAT
HEAD SCREWS (12S).
å
NOTE: Do not overtighten the SCREWS into the
DRAWER FRONT MOLDING.
3
U n fi
n i s h
D701
D12
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D701) into the
grooves in the DRAWER SIDES (D12 and D13) and
DRAWER FRONT (L).
www.sauder.com/service
(2 used in this step)
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
e d
s u r
f a c
e
D13
L
2
12S
Groove
å
Insert the DRAWER SIDES (D12 and D13) at an angle
into the slot at each end of the DRAWER FRONT (L).
4
D12
å
Fasten the DRAWER BACK (D62) to the DRAWER
SIDES (D12 and D13). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
423392
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D12
D13
L
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
D62
D13
9
30S
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 25
Publicidad
