Publicidad
Step 1
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor.
å
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into
the RIGHT END (A) until the shoulders of the SCREWS
rest on the surface of the END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide one of the END MOLDINGS (M) onto the END (A).
Line up the groove in the MOLDING over the heads of the
SCREWS in the END.
å
NOTE: The MOLDING should be centered on the END.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
www.sauder.com/service
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
32S
A
423392
Remember:
Righty tighty.
Lefty loosey.
M
Shoulder
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
0
Page 5
Publicidad
