Publicidad
Step 21
å
NOTE: Before fastening the KNOB SET (157K), the post on the
backside of the BACKPLATE must be tapped into the DRAWER
FRONT. To do so, insert a GOLD 1" MACHINE SCREWS (50S)
through the DRAWER FRONT then through the BACKPLATE to
locate the BACKPLATE properly. Be sure it is straight. Next, place
a cloth or the instruction book over the BACKPLATE and gently
tap the post into the DRAWER FRONT using your hammer.
å
Fasten two KNOB SETS (157K) to the DRAWER FRONT (L). Use
two GOLD 1" MACHINE SCREWS (50S).
157K
Page 26
50S
GOLD 1" MACHINE SCREW
(2 used in this step)
L
423392
NOTE: You need to
gently tap the post
into the DRAWER
FRONT as instructed.
www.sauder.com/service
Publicidad
