EUFY RoboVac Manual Del Propietário página 10

English
Select a Cleaning Mode
1. Auto cleaning
RoboVac optimizes its cleaning path by selecting different cleaning modes automatically
until cleaning is complete. This is the most commonly used cleaning mode.
Press on RoboVac or / on the remote control to start cleaning in Auto Mode.
- RoboVac will return to the Charging Base automatically when the battery level becomes
low or when RoboVac finishes cleaning.
- By default, RoboVac starts in Auto cleaning mode when it is turned on.
BoostIQ™ Feature
When the BoostIQ™ feature is enabled, RoboVac will automatically increase the suction
power if it detects stronger power is needed to ensure the best clean. BoostIQ™ is ideal for
cleaning thicker carpets and hard-to-sweep messes, which will reduce the total cleaning
time, but increase the noise level. If the vacuuming noise caused by BoostIQ™ disturbs
you, you can disable this feature. This feature only works in Auto and Single Room cleaning
modes.
In Auto or Single Room cleaning mode, press
the suction power level.
• The corresponding icon is displayed on the remote control.
Icon Suction Power Level
Standard power
Standard
Automatically switches between Standard and Enhanced power (default)
BoostIQ
Maximum power
Max
When RoboVac starts cleaning in Auto or Single Room mode the next time, it will
clean according to the suction power level you previously selected.
16
on the remote control repeatedly to adjust
1. Spot cleaning
RoboVac intensively cleans a specific area in a spiral, useful if there is a concentrated area
of dust or debris. In Spot mode, RoboVac will stop cleaning after 2 minutes.
Press on the remote control to start cleaning in Spot mode.
2. Edge cleaning
RoboVac reduces its speed when it detects a wall and then follows the wall to ensure the
edge is cleaned thoroughly. In Edge mode, RoboVac will clean for 20 minutes and return to
the Charging Base.
Press on the remote control to start cleaning in Edge mode.
English
17