Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
After changing the bevel angle, always secure the
•
arm by tightening the lever clockwise.
NOTICE:
When tilting the saw blade be sure the handle is
•
fully raised.
When changing bevel angles, be sure to position
•
the kerf boards appropriately as explained in the
"Positioning kerf boards" section.
Adjusting the lever position
1
2
003932
The lever can be repositioned at every angle 30° when
the lever does not provide full tightening.
Loosen and remove the screw that secures the lever at
the rear of the tool. Remove the lever and install it again
so that it is slightly above the level. Secure the lever with
the screw firmly.
Switch action
1
2
011243
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
WARNING:
Before installing the battery cartridge on the
•
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released. Do not pull the switch
trigger hard without pressing in the lock-off
button. This can cause switch breakage.
Operating a tool with a switch that does not actuate
properly can lead to loss of control and serious
personal injury.
A hole is provided in the switch trigger for insertion of a
padlock to lock the tool off.
1. Lever
2. Screw
1. Lock-off button
2. Switch trigger
3. Hole for padlock
3
WARNING:
Do not use a lock with a shank or cable any
•
smaller than 6.35 mm (1/4") in diameter. A
smaller shank or cable may not properly lock the
tool in the off position and unintentional operation
may occur resulting in serious personal injury.
NEVER use tool without a fully operative
•
switch trigger. Any tool with an inoperative switch
is HIGHLY DANGEROUS and must be repaired
before further usage or serious personal injury may
occur.
For your safety, this tool is equipped with a lock-off
•
button which prevents the tool from unintended
starting. NEVER use the tool if it runs when you
simply pull the switch trigger without pressing the
lock-off button. A switch in need of repair may result
in unintentional operation and serious personal
injury. Return tool to a Makita service center for
proper repairs BEFORE further usage.
NEVER defeat the lock-off button by taping down or
•
some other means. A switch with a defeated
lock-off button may result in unintentional operation
and serious personal injury.
Electric brake
This tool is equipped with an electric blade brake. If the
tool consistently fails to quickly stop the blade after the
switch trigger is released, have the tool serviced at a
Makita service center.
CAUTION:
The blade brake system is not a substitute for
•
the blade guard. Never use tool without a
functioning blade guard. An unguarded blade
may result in serious personal injury.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off and
•
the
battery cartridge is
working on the tool. Failure to switch off and
remove the battery cartridge may result in serious
personal injury.
9
removed
before
Publicidad
