Andis MLC Instrucciones De Uso Y Cuidado página 6

touch metal terminals with metal objects and/or
body parts, as short circuit may result. Keep away
from children. Failure to comply with these warnings
could result in fire or serious injury.
15. This appliance is only to be used with the power supply
unit provided with the appliance.
16. This appliance is only supplied at safety extra low voltage
corresponding to the marking on the appliance.
17. This appliance contains batteries that are only
replaceable by skilled persons.
18. Keep the appliance dry.
SAVE THESE INSTRUCTIONS
UNIVERSAL AC/DC POWER ADAPTER
The unit/charging stand is equipped with a universal AC/DC power adapter. Interchangeable input plugs
are included for use in most countries around the world (Figures A-F). Plugs may vary by model.
REMOVING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. While pressing down on button located on input plug, gently push up on plug until it releases from
power adapter.
REPLACING INPUT PLUG:
1. To replace input plug, align tabs on the AC/DC power adapter with slots on input plug (Figure G).
2. Gently push input plug into power adapter until it snaps into place.
USER INSTRUCTIONS
• The battery is not intended to be replaced by the user.
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the battery.
• The battery is to be disposed of safely.
CHARGING CLIPPER USING CHARGING STAND
The AC adapter is intended for use with Andis model MLC lithium-ion clipper battery with a rated capacity
of 4.5V 1.2A. Remove the clipper and AC adapter from the carton. Plug the AC adapter into a 120-240V AC
outlet, or according to your local power standards. Plug the adapter cord into the receptable on the back
of the charging stand (Figure H). Place clipper in the charging stand. The ON/OFF switch on the clipper
must be in the OFF position for the battery to charge. The blue light on the clipper will fade in and out
while charging. Note that the clipper can be removed at any time during the charging cycle without
harming the clipper or battery. Once the battery is fully charged, the light on the clipper (Figure I) will
turn solid blue.
The clipper has not been charged at the factory. Please charge the clipper for 2 hours before the
first use for maximum performance.
You can keep the clipper plugged into the charging stand or adapter when not in use. The charging stand
or adapter will maintain the battery at full charge. We recommend that the charging stand or adapter be
unplugged if the clipper won't be used for seven or more days.
6