Andis MLC Instrucciones De Uso Y Cuidado página 9

11. With the lever arm in the shortest position (upright) set the blade gap of the upper blade to your
preference, taking care that it does not overhang the lower blade, as this can cause damage to skin
(the blades are gapped at 1/32" from the factory) (Figure O).
12. Reattach the two blade screws, once again confirming that the upper blade does not travel over the
lower blade while the lever arm is in the shortest position (upright) (Figures N & O).
USE GUIDELINES FOR LITHIUM-ION BATTERIES
1. The lithium-ion battery included with your clipper does not develop a "memory effect" like a nickel-
metal hydride (NiMH), or nickel cadmium (NiCd) battery. You can return the clipper to the charger at
any time for a full charge, or even use the battery before a charge cycle is complete. Like most
rechargeable batteries, lithium-ion batteries perform best when used frequently.
2. For maximum battery life, store the clipper in a partially discharged condition if the unit will be unused
for several months. To discharge the battery, run the clipper under normal conditions. Battery should
be recharged again before re-use.
3. Avoid locating the clipper near heat vents, radiators, or in direct sunlight. Optimum charging will result
where the temperature is stable. Sudden increases in temperature can result in the battery receiving
less than a full charge.
4. Many factors influence lithium-ion battery life. A battery that has received heavy use or is more than a
year old may not give the same run-time performance as a new battery pack.
5. New lithium-ion batteries, unused for a period of time, may not accept a full charge. This is normal and
does not indicate a problem with the battery or charger. The battery will accept a full charge after
several cycles of clipper use and recharging.
6. Disconnect the charger or the clipper from the AC outlet if extended periods of non-use are
anticipated.
DISPOSAL OF BATTERY PACKS
As a consumer you are legally obliged to dispose of batteries and battery packs as special waste.
Information regarding how to remove the battery pack from the relevant device at the end of its
life can be found on the page 110. After removing the battery pack, the device must be disposed of and
may NOT be used again. Check with your local solid waste officials to locate a collection facility or to get
details in your area for recycling options or proper disposal.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection systems or contact
the retailer where the product was purchased. They can take this product for environmental
safe recycling.
BLADE & CLIPPER REPAIR SERVICE
When the blades of your Andis clipper become dull after repeated use, it is advised to purchase a new set
of blades available through your Andis supplier. Some blade sets can be resharpened - contact your Andis
supplier or the Andis Company for information on resharpening. If you wish your clipper to be serviced
as well, contact your Andis supplier. To find an Andis authorized service station, contact the Andis
Company Customer Support Team at 1-262-884-2600, or by email at support@andisco.com.
CAUTION: Never handle your Andis clipper while you are operating a water faucet and never hold your
clipper under a water faucet or in water. There is danger of electrical shock and damage to your clipper.
ANDIS COMPANY will not be responsible in case of injury due to this carelessness.
9