Altrad Belle RTX 50 Manual Del Operador página 21

Pre start-up inspection
1. Thoroughly inspect the RTX for signs of damage.
leaks before operating.
3. Check the Engine Oil level and top up as necessary.
level. To achieve this place the Rammer in the position shown below.
4. Check the Engine Fuel level and top up as necessary. Use clean Fuel. Use of contaminated
Fuel may damage the Fuel system.
NOTICE: This machine uses Unleaded Gasoline/Petrol.
CAUTION
NEVER
6.2 The minimum level is shown by the Red Dot on the Oil Sight Glass within the Rammer Leg. (SAE 10W-30 Mineral Oil
The chemical composition of fuel will deteriorate after prolonged storage. When the machine needs to be
Clean up oil and dust accumulation on rubber parts.
Clean the ramming shoe and apply a light coating of oil to prevent rust formation.
Cover the machine and store in a dry place.
Pre-Start Checks
Rammer Leg Oil
Check Position
Long Term Storage
Engine Oil
Check Position
(Petrol Only)
21
RTX must not be used until the fault
(Petrol Only)
GB
-
GB