Publicidad
1
Safety Warning Messages
performance and prolong its service life, for your safety and the safety of others,
•
In order for you to use, maintain your e-bike correctly, make it perform its best
please take some time carefully to read this manual.
do not use e-bike, and do not lend them to people who can't operate e-bike to
•
avoid unnecessary damage to your e-bike.
Before reading this manual and understanding the performance of e-bike, please
•
For the safety and happiness of you and others, please abide by local traffic laws.
tact with metal at the same time, otherwise it will generate a large short circuit
•
current and cause an accident.
Do not touch the power port of the battery box used in this e-bike, let alone con-
will also damage the battery life, so you should fully charge and store it in time after
riding. If the battery is not used for a long time, please charge the battery to a half full
•
state and store it at 80%, and remove the key. It is best to recharge it every 2 months.
Insufficient battery not only affects the continued mileage, long term under voltage
rage in places with high air humidity and corrosive gas, so as to avoid chemical
corrosion and electrical parts damage on the electroplating and painted surfaces
•
of various parts.
The e-bike should avoid long-term exposure to the sun and rain, and avoid sto-
into the brake pads because the brakes fail. When driving downhill on snowy, rainy
•
days, please pay attention to driving slowly to ensure safety.
Please regularly check whether the brake performance is good. Do not inject oil
•
Random modification of the e-bike, or replacement of the original e-bike, device
will not guarantee the safety of the e-bike.
semble parts by yourself. If repair or r eplacement is required, please contact the
•
dealer or professional maintenance personnel.
For your personal safety and consumer rights, please do not disassemble or disas-
– EN -
18
•
ensure your safety.
Please carefully check whether the parts are in good condition before use to
•
Please consciously abide by the traffic rules.
•
Do not put the battery near high temperature or put it into fire. When charging, do
not near flammable and explosive materials.
•
When riding in crowded places, please ensure that the environment is safe to
assist the riding or turn off the power to avoid danger.
•
When disposing of the battery, please discharge the battery voltage to 0 volts. The
lithium battery is a flammable. please do not throw it into the fire.
re leaving the factory. The technical parameters of the charger are fully matched
with the parameter design of the battery protection board; the electronic anti-in-
terference compatibility is good. If the charger is lost, use another manufacturer's
charger. Due to the mismatch of electrical parameters and mutual interference,
the battery pack may be damaged and its service life may be shortened. It is also
•
The relevant certifications of our charger and battery pack are strictly tested befo-
possible that the battery pack will be overcharged, suffocated, or even ignited.
rameter has been verified by many tests. Please use the original factory-configu-
red controller. Because the under- voltage protection hedging design of the con-
troller is based on the protection parameter design and matching compatibility
performance of the battery pack protection board. If you use an unmatched
controller, it may affect the over-discharge of the battery pack and damage the
service life of the battery pack. It may also interrupt the power of the entire e-bike
•
during riding, and may also reduce the life of the motor.
The combination of our battery pack and controller is very important. This pa-
– EN -
19
Publicidad
