Publicidad
4. Step 4: Upside down the bicycle, insert the front wheel, then
insert the hook, washer, and nut on both sides accordingly, and
tighten the nut to finish the assemble ( As: Figure 3.4.1 )..
Step 5: Insert the seat tube, adjust the height of seat tube. When locking, please
keep the seat cushion level (according to personal preference).
Important: The seat tube bundle must be locked, and the depth of the seat tube
must be at or above the safety line.
(As: Figure 3.6 )
Figure 3.5
– EN -
26
6. Step 6: Because the tooth patterns on the left and right of the pedal are dif-
ferent, the installation method is different, L on the left / R on the right. Use R to
lock the crank in the clockwise direction, and use L to lock in the counterclockwise
direction on one side of the crank
( As: Figure 3.6 ).
Figure 3.6
7 7 7 . . . Step 7 Mount the holder on the handle bar:
7.1 Position washer 1 with holder & under the handlebar
4
7.2 Put on the washer 2 on the top of handle bar
7.3 Put the clip to cover the washer 2
7.4 Tighten with screws
( As: Figure 3.7.1 & 3.7.2 & 3.7.3 )
Washer 2
Holder
Washer 1
– EN -
Clip
F F F i i i g g g u u u r r r e e e 3 3 3 . . . 7 7 7 . . . 1 1 1
27
Publicidad
