Publicidad
3
Assemble
1. The f irst step: After unpacking the entire kit, lift the steering column, set it in
the right position and lock the latch (Always wear: Figure 3.1).
2. The second step: Install the handle, adjust the angle of the driver.
– EN -
24
The seat tube and the front wheel are facing straight ahead at the
same time. Then lock the handlebar on the riser, ensure the quick
!
release be locked. Please pay attention to the angle and direction
of the handlebar (the transmission and the battery display are on
the left side of the front.
Please adjust the handlebar to a comfortable angle.
( As: Figure 3.2.1 & 3.2.2 ).
3. Step 3: Install the headlights and mudgard onto the front fork
using screws and nuts from the fitting. ( As: Figure 3.3.1 & 3.3.2 ).
– EN -
ntaż
25
Publicidad
