• 3
DAILY CARE OF YOUR APPLIANCE
3. 1
-
M A I N T A I N I N G
APPLICANCE
Igniters and injectors:
If the igniters become dirty
them with a small, stiff (non-metallic)
brush (3.1.1).
The gas injectors are located in the
centre of each burner in the well shape.
Ensure that you do not block them
during cleaning, which could impair your
hob's performances.
If you do block them, use a safety pin to
unblock the injector. (3.1.2)
Pan holders and gas burners:
For persistent stains, use a non-abrasive
cream, and then rinse with clean water.
Carefully wipe each part of the burner
before using your hob again.
Enamel part:
the enamelled part should be cleaned
with a sponge and soapy water or with a
mild detergent.
Do not use abrasive or corrosive pro-
ducts.
Stainless steel :
To clean the hob's stainless
use a sponge and soapy water or a
commercially available stainless steel
cleaner.
Do not allow acid liquids such as lemon
juice, vinegar, etc. to remain on the
enamelc.
Y O U R
Your hob will be easier to maintain
if done prior to use. Turn off all electrical
and gas controls.
A
clean
Preferably clean hob components
by hand rather than in the dishwasher:
• do not use scourers to clean your hob.
• Do not use steam cleaners.
• After cleaning the burner, make sure
that the lid is placed in the housing.
• The burner cap must be positioned
steadily and flat.
steel,
13