Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Switch
Cup Cover/ Light Kit/
Light Shade
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
1. Loosen but do not remove two of three
mounting screws from the fan motor
assembly; Remove one mounting screw.
(Figure 15)
2. Push the switch cup cover up to the fan
motor assembly so that the two loosened
screw heads fit into the keyhole slots. Turn
the switch cup cover clockwise, tightened
the screws. Re-install the screw that was
removed in step 1 and tighten firmly.
(Figure 15)
3. Remove one screw from the switch cup
cover and loosen, but do not remove the
other two screws. Connect the wires from
the light kit to the wires from the fan motor
assembly by connecting the molded adaptor
plugs together. Carefully tuck all wires and
splices into the switch cap. (Figure 16)
4. Push the light kit up so that the two
loosened screw heads fit into the keyhole
slots. Turn the light kit clockwise, tighten
the screws. Re-install the screw that was
removed in step 3 and tighten firmly.
(Figure 16)
9.
5. Loosen but do not remove the three screws
from the light fitter assembly. (Figure 17)
6. Carefully slide the glass shade completely
into the outer rim of the light kit fitter
assembly so that the ridge of the glass bowl
aligns with screw holes in the outer rim.
(Figure 18)
7. Secure the glass shade by finger tightening
the three screws until they touch the glass
shade. Do note over-tighten the screws.
(Figure 18)
White
Molded
Adaptor Plugs
Figure 15
Figure 16
Figure 17
Figure 18
Publicidad
