Woods WCD4FC Instrucciones De Uso página 2

OPERATION
Built in Electrical Safety
For your safety and protection this appliance is manufactured
with a grounded plug on its power cord. The power cord must
be plugged into a properly grounded receptacle. If a grounded
receptacle does not exist, have one installed by a certified elec-
trician. Do not cut or remove the grounding prong on the power
cord plug if equipped. We recommend that this electrical cir-
cuit/receptacle operate under a separate breaker or fuse.
Location of Unit
Minimum 25cm distance from walls. Close all doors and win-
dows.
Initial Start-up
Check the rating plate for the appropriate power supply need-
ed by your unit. This will be one of the following : 230 Volt 50
Hz, 115 Volt 50 Hz or 120 Volt 60 Hz. Connect the dehumidifi-
er. Ensure that one of the water collection options is working
and active. Depress the ON switch.
Control Panel Settings
ON/OFF Switch
Depress the switch to start or stop the
dehumidifier. "O" for power off, "I" for
power on.
Hour Counter
The counter will accumulate and dis-
play the total running hours of the unit
in 1/100 of an hour. It can not be reset
to zero. No user input is required.
Automatic Defrost Cycle
All units are equipped with an automatically activated (ther-
mostat controlled) Defrost cycle to automatically defrost the
evaporator coils.
Removing Collected Water
The water collected from the air can be disposed in one of
four convenient ways:
Water container: Remove and empty. See diagram. Start the
removal of the water container by first opening the water com-
partment doors (depress the black spring loaded door latch
downward thus allowing the door to rotate down towards the
ground). Slide the water container out by grasping the top rim
of the container. Remove the water container by gripping the
container with both hands, then sliding out of the water com-
partment.
Gravity Drain: Place the dehumidifier directly over an existing
floor drain.
Hose Attachment: On some models, a universal drain adapter
is included. This can be threaded to the bottom of the plastic
drip tray. Connect the hose to the drain adapter.
Condensate Pump: Some of our models come already
equipped with an electrically powered Condensate pump. If
your model is not equipped with one, then a condensate pump
kit can be purchased seperately. The necessary internal electri-
cal connections already exist in every unit.
Cleaning
DANGER: Electrical shock hazard. Disconnect power
before cleaning.
Exterior Parts
Use a mild, non-abrasive soap and clean water solution to
clean the painted metal cabinet, handles and wheels. Wipe dry.
Air Filter
Remove filter. Wash in a mild soap and water. Rinse with clean
water. Air dry before reinstalling. Torn or ripped filters should be
replaced with a new filter.
Fan Motor
Does not require lubrication.
Condenser and Evaporator Coils
1. Light cleaning: Remove the air
filter and spray evaporator coil with
water.
2
A qualified refrigeration technician must service all refrig-
erant leaks.
Important - If power to the unit is disconnected or unit is turned
off, allow 3 minutes before restarting the dehumidifier. This
allows the internal pressures to equalize.
Storage:
Single unit: It is best to cover the unit if extended storage peri-
ods are contemplated. Remove all water in collection system.
Stacking Two Units: This dehumidifier can be stacked two high.
An assembled unit weighs 39 kgs. Position on a level surface.
WARNING: Personal injury hazard. Use two individuals to lift.
Maximum stacking height: 2 units
This appliance complies with the suppression requirements of
EEC directive 76/889 + 82/499. Recommended limits of use:
Temperatures: 0 to 35°C, Relative humidity: 20 to 80%.
2
1
2. Heavy cleaning: Open upper door.
Remove plastic cleanout by pushing
the two locking tabs and lifting. Spray
water at coils. Replace the cleanout.