Woods WCD4FC Instrucciones De Uso página 4

Wheel / Handle Assembly
1
Position unit on back. Remove 4 shipping
screws and discard.
3
Install one short tube on wheel axle.
5
Install one short tube. Install one pointed
screw and tighten.
7
Install washer and lynch pin to each
wheel axle end.
2
Slide wheel axle into wheels brackets.
Offset to one side.
4
Install bent handle on short tube. Install
one pointed screw and tighten.
6
Install two wheels on wheel axle.
WARNING: Personal injury
hazard. Do not place fingers in
ring area. Ring is spring
loaded and closes with force.
Lower Door, Second Handle Assembly
8
Position unit with air filter up.
10
Insert bent tube into long tube. Rotate
long tube to align with cabinet hole and
insert one pointed screw. Do not tighten.
12
Insert two pointed screws. Tighten all
pointed screws.
4
9
Install one long tube, plastic bushing
faces inward. Insert one pointed screw.
Do not tighten.
11
Insert hand axle. Insert second long tube.
13
Position unit upright. Wait 30 minutes
before starting to allow compressor to
drain back.
!