Garland XTRIM 355 E Manual De Instrucciones página 30

English
Tug each thread until each has released 12 cm.
Carefully put the lower cover on (1).
6.2.3. HOLDING THE CABLE EXTENSION
6.3. START UP
6.3.1. CHECK POINTS BEFORE STARTING
The voltage and current supply must comply with the
indications on the rating plate. Before starting to work,
always make sure that the appliance works correctly
and that your operation is safe.
Do not use this device if it is damaged or insufficiently
regulated.Only use this machine.
Only use this machine for the purposes for which it
was designed. Any other use may be dangerous for
the user, for the device, and for the people, animals
and objects surrounding it.
Check:
- The machine and locate loose and/or damaged
parts (screws, nuts, etc.).
- That the guard is properly attached to the machine.
- That the head is not damaged.
Tighten, repair or replace everything you need before
using the machine.
6.3.2. ADJUSTABLE HANDLE
6.3.3. TELESCOPIC REGULATION
1. Loosen the ring by turning it in the direction
marked by the unlock arrow.
2. Lengthen or shorten the pole to desired length
3. Tighten the ring by turning it in the direction
marked by the arrow.
Be sure that you pressed the ring tight enough before
starting up the machine.
6.3.4. TURNING ON AND OFF
To turn the machine ON:
Press the Om/Off switch (A).
To turn the machine OFF:
Release the On/Off switch (A).
30/112