Garland XTRIM 355 E Manual De Instrucciones página 31

A
After the machine is switched off the blade will
continue to turn because of inertia.
Wait until the blade stops before carrying or
performing maintenance work on it.
6.3.5. CHECKPOINTS AFTER TURNING THE MACHINE
ON
It is important to pay attention to the possible loose
parts and/or the temperature of the machine. If you
detect anything unusual in the machine, immediately
stop and check it carefully. In case of any malfunction
or problem take the machine to be repaired.
Never continue to use the machine if the operation
does not seem appropriate. Do not use the machine if
it is damaged or incorrectly adjusted.
7. MACHINE USAGE
Only use this machine for applications for which
it has been designed. The inappropriate use of this
machine is dangerous and may cause damage to the
user or machine.
Work only in daylight or with adequate artificial light.
Do not use this machine at night, with fog or
with a low visibility that does not allow you to see
clearly in the work area
Limit the time of use of the device to 10 minutes, and
take a 10-20 rest between each session.
Avoid operating the machine when the soil is wet
whenever possible. Be especially careful if you use the
machine after it has been raining, since the ground
may be wet and you might slip.
If you slip, lose your balance, or fall release the ON/
OFF switch immediately.
Do not use this machine if you are tired, sick, under
the influence of drugs drugs, narcotics or alcohol.
Fatigue and lack of rest can cause accidents or
damage.
Always readjust the machine on a flat and stable
surface.
Do not use this machine on slopes where your safety
is not guaranteed. If you are working on a sloped
surface, slow down and make sure you are well
balanced and stable.
Stay away from the blade when the device is in
motion.
Do not only rely on the safety devices of this
machine.
It is vital to pay attention to the possible loosening
or overheating of the different parts of the machine.
If you detect anything unusual, stop the machine
immediately and check it carefully. In case of
malfunctions, take the machine to be repaired. You
should never continue to work with this machine if you
detect any problems.
Remember to always use the machine with clean
hands, rather than greasy or oily hands.
Do not use pieces on this machine except those
recommended by our company since they may cause
damage to the user, to anyone close to the machine
and to the machine itself.
31/112
English