Publicidad
Idiomas disponibles
Idiomas disponibles
Telephone Helpline: 0845 146 2887 (United Kingdom)
Parameter
Name
Compressor Operation
=23
During Probe Failure
Compressor 'On'
=24
Duration
Compressor 'Off'
=25
Duration
Initial Defrost After
=34
Startup
Minimum
=38
Temperature Alarm
Manual Defrost
The appliance will automatically run a defrost cycle every six hours.
Note: The cycle starts from the time the appliance is initially powered up.
To manually defrost the appliance:
Press and hold the DEFROST
1.
The defrost cycle will start immediately and the Defrost LED illuminates. The defrost will last a maximum of 30 minutes.
2.
Note: Starting a manual defrost also resets the automatic defrost timer.
The next automatic defrost will start six hours after the manual defrost has finished.
Waste water is collected in the waste water tray.
3.
Cleaning, Care & Maintenance
•
Switch off and disconnect from the power supply before cleaning.
•
Clean the interior of the appliance as often as possible.
•
Do not use abrasive cleaning agents. These can leave harmful residues.
•
Clean the door seal with water only.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
•
Take care when cleaning the rear of the appliance. Sharp edges can cut.
•
A POLAR agent or qualified technician must carry out repairs if required.
Marble Care
•
Do not use abrasive materials or detergents to clean the worktop. Wash with warm, soapy water.
•
Dry thoroughly with a soft cloth after cleaning.
•
Wipe up any spillages as quickly as possible, particularly liquids such as lemon juice or vinegar.
•
POLAR recommend the use of a chopping board to reduce the risk of damage to your worktop.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance.
POLAR recommend that a POLAR agent or qualified technician clean the condenser.
Description
Set whether the compressor runs or remains Off during a temperature probe
failure
Set the length of time the compressor runs during a temperature probe failure 1-99 minutes
Set the length of time the compressor remains Off during a temperature
probe failure
Set whether the appliance starts a defrost cycle 10 minutes after startup or
after the time programmed in parameter d8 (Defrost Cycle Time Intervals)
Set the display to flash should the inner temperature of the appliance drop
beyond a specified point from the programmed operating temperature
button for 5 seconds.
Default Parameter Value
Range
Base
Compressor runs (1)
Remains Off until fault
fixed (0)
2
Runs intermittently
with parameters =24
and =25 (2)
10
1-99 minutes
10
Begins 10 minutes
after startup (0) or
n/a
when programmed
(1)
1°C to 50°C
40°C
UK
Top
2
10
10
n/a
40°C
4
Publicidad
