Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Place the wall plate template
14
template
and tape in place.
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.
IMPORTANT
: Be sure you mark and drill into the center of the stud.
5.
Drill the two pilot holes using a 5.5 mm (7/32 in.) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 75 mm (3 in.).
6.
Remove the wall plate template
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage Do not over-
17
tighten the lag bolts
20
Fit lag bolt covers
4
10
14
at your desired height and position the slotted holes over your stud center line. Level the wall plate
14
. Tighten lag bolts
.
17
over lag bolts
.
5
14
All manuals and user guides at all-guidesbox.com
17
18
only until the washers
75 mm
(3 in.)
5.5 mm
(7/32 in.)
14
are pulled fi rmly against the wall plate
6
18
17
.
15
15
20
Publicidad
