Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
10
1. Remove dust, loose staples and other particles
which may have collected in the unit.
2. Lubricate the insert stapler with a few drops of
thin oil after about 10.000 staplings, as shown
in the sketch. Wipe off excess oil.
11
BREAKDOWNS
A. Test the function of the insert stapler by hand.
1. Remove staples stuck in the outlet. Check that
correct staples have been used and that the
staple outlet is undamaged.
2. Change the insert stapler when damaged or
worn.
B. The operating system. Check that:
1. the unit is receiving current, and that the switch
is on (the pilot light comes on).
2. the sight-shield is down.
3. the correct method of activating is used. If the
foot control or opto cable is connected the trig-
ger will not operate.
4. the triggers return forward easily after activa-
ting. Both must return to "stop" before the next
stapling.
5. correct impact force has been chosen. If the
faults remain, return the unit to your supplier or
to an authorised service man. Do not use a
machine with a faulty connecting cable or plug.
CHANGING THE INSERT
12
STAPLER - RAPID 105
1. Remove the locking plate (13) with its screw
(5).
2. Change the insert stapler. Press the plunger
(28) upwards when entering the new insert sta-
pler.
3. Fasten the locking plate (13).
CHANGING THE INSERT
13
STAPLER - RAPID 106
1. Remove the fixing knob (15) with screw and
remove the table (16)
2. Loosen the two screws (26) and pull out the
insert stapler. Press up the plunger (28) and
remove the insert stapler.
3. Fit the new insert stapler by first inserting the
catch-plate (19) in the up position over the anvil
(8).
4. Press up the plunger (28) and lower the catch-
plate (19) with the narrow part pointing into the
machine.
5. Push in the insert stapler while holding up the
plunger. Important! Be sure that the narrow
part of the catch-plate enters its guide hole.
6. To maintain perfect stapling it is necessary to
adjust the position of the insert stapler towards
the anvil. This adjustment is achieved by using
the guide plate (27) enclosed with the machine.
Open the magazine and insert the guide plate
from underneath in the magazine outlet. Insert
magazine. Press down the insert stapler and
make sure that the guide plate fits well into the
anvil. Keep insert stapler pressed to the anvil
and tighten the mounting screws (26). Remove
the guide plate from magazine and do a few
trial staplings to check proper function.
7. Fit the table in place. NOTE: the table's strut,
screw and fixing knob (15) must be positioned
in front of the tubular stand.
Equivalent noiselevel dB(A) at maximum capacity
and power.
Ex. 1440 staples per 8 hours give 70dB(A) (A106).
Noise measurement made according to ISO 7779
with supplement proposal "Electrical staplers:
Noise test code".
The 70 dB(A) equivalent noise level is a German
requirement for maximum noise level in common
areas such as shops, airport check in, receptions
and other simular areas.
6
GB
Publicidad
