Flex FX1611 Manual Del Operador página 10

CHANGING BIT HOLDER
WARNING
placing the direction-of-rotation selector in
the center position.
a. Pull the stop sleeve out and remove it from
the tool (Fig. 5).
b. Push the clutch toward the rear of the tool and
pull the bit holder out from the gearcase
(Fig. 6).
c. Push the clutch toward the rear of the tool and
push the bit holder into the gearcase.
d. Release the clutch and ensure that the
bit-holder shank is locked in the gearcase
securely.
e. Attach the stop sleeve to the tool.
CHANGING SCREWDRIVER BIT
WARNING
placing the direction-of-rotation selector in
the center position.
a. Pull the stop sleeve out and remove it from
the tool (Fig. 5).
b. Remove the worn screwdriver bit with pliers
and install the new bit (Fig. 7).
c. Attach the stop sleeve to the tool.
WARNING
from the tool, or first allow the bit to cool
down. The bit may be hot after prolonged
use.
Lock the variable-speed
trigger switch "OFF" by
Lock the variable-speed
trigger switch "OFF" by
Use protective gloves
when removing the bit
Fig. 5
Stop Sleeve
Fig. 6
Bit Holder
Fig. 7
Screwdriver Bit
-10-
"click"
Gearcase
Clutch