Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE: Do not grip the rotating screwdriver
head during operation (Fig. 13).
Screwing in screws:
a. Insert an appropriate screwdriver bit.
b. Set the screw-in depth.
c. Set the direction of rotation to forward
rotation.
d. Grip the tool with one hand on the handle and
assume a working position.
e. Place a screw on the screwdriver bit. The
screw is held by magnetic force.
f. Press the screw tip against the workpiece to
be screwed in place until the stop sleeve is
positioned on the workpiece. Hold the tool at
right angles to the surface of the workpiece.
g. Turn on the tool. The screw is screwed into
the workpiece until the set screw-in depth is
reached.
Check the screw-in depth, change if required.
NOTICE: When the preset screw-in depth
is reached, the drive is disengaged and the
screwdriver bit stops turning.
h. When you have finished driving screws, turn
off the tool.
i. At the end of work, move the direction-of-
rotation selector to the center-lock position.
Loosening screws:
a. Insert an appropriate screwdriver bit.
b. Set direction of rotation to reverse rotation.
c. Grip the tool with one hand on the handle and
assume a working position.
d. Place the screwdriver bit on the screw to be
loosened.
e. Turn on the tool by pressing the variable-
speed trigger switch to loosen the screw.
f. After loosening the screw, release the trigger
switch.
g. At the end of work: move the direction-of-
rotation selector to the center-lock position.
NOTICE: The screwdriver bit will not turn
until pressure is applied to the screw. Push to
engage.
Fig. 13
X
X
-14-
√
√
Publicidad
