Descargar Imprimir esta página

Flex FX1611 Manual Del Operador página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

LED LIGHT (FIG. 12)
Your tool is equipped with an LED light, located
on the base of the tool. This provides additional
light on the surface of the work piece for
operation in lower-light areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running and will turn
off approximately 10 seconds after the variable-
speed trigger switch is released.
The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or too
hot, and the internal sensors will turn the tool
off. Rest the tool for a while or place the tool
and battery pack separately under air flow to
cool them.
The LED light will flash more slowly to indicate
that the battery is at low-battery capacity.
Recharge the battery pack.
If the LED fails to light up when you switch on
the tool, or it turns off suddenly during your
operation, it may be caused by the internal
communication error. Please contact customer
service or an authorized service center for
assistance.
WARNING
product damage due to a short circuit, never
immerse your tool, battery pack or charger
in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
This cordless drywall screwdriver must be used only with the battery packs and chargers
listed below:
2.5Ah
5Ah
FLEX FX0111
FLEX FX0121
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
To reduce the risk of fire,
personal injury, and
If any parts are damaged
or missing, do not operate
Battery Pack
8Ah
FLEX FX0221
Fig. 12
LED Worklight
Workpiece
WARNING
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious injury.
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
parts, making adjustments, or cleaning the
tool.
12Ah
FLEX FX0231
-13-
Do not attempt to modify
this tool or create
To prevent accidental
starting that could cause
Charger
FLEX FX0411
FLEX FX0421

Publicidad

loading