SICK WL24-2 Instrucciones De Uso página 13

8 Devices with special features
9 Troubleshooting
10 Disassembly and disposal
11 Maintenance
8008783.1DMA/2022-07-12 | SICK
Subject to change without notice
WL24-2xx4x: with static front-screen heating for use in environments with gradual
temperature changes within the +5 °C ... +15 °C range.
WL24-2B230S02: glass front screen
WL24-2V240S03: M16 connector, glass front screen, dynamic power heating on the
rear side of the glass, current consumption: 150 mA. The dynamic power heating is
automatically switched on and off depending on the ambient temperature (23-26 °C).
For the use of quick temperature changes in the range of <0 °C...+10 °C
WL24-2V530S04: M12 male connector, 5-pin, glass front screen, dynamic power heat‐
ing on the rear side of the glass, current consumption: 150 mA. The dynamic power
heating is automatically switched on and off depending on the ambient temperature
(23-26 °C). For the use of quick temperature changes in the range of <0 °C...+10 °C
WL24-2R240S05: PG9 connector
WL24-2B430T01: housing is coated with Teflon
The Troubleshooting table indicates measures to be taken if the sensor stops working.
The sensor must be disposed of in line with applicable country-specific regulations.
When disposing of them, you should try to recycle them (especially the precious met‐
als).
NOTE
Disposal of batteries, electric and electronic devices
•
According to international directives, batteries, accumulators and electrical or
electronic devices must not be disposed of in general waste.
• The owner is obliged by law to return this devices at the end of their life to the
respective public collection points.
•
WEEE: This symbol on the product, its package or in this document,
indicates that a product is subject to these regulations.
This SICK sensor is maintenance-free.
We do, however, recommend that the following activities are undertaken regularly:
• Clean the optical interfaces using a plastic cleaner, do not use acetone or methy‐
lated spirits.
• Check the fittings and plug connectors
No modifications may be made to devices.
Subject to change without notice. Specified product properties and technical data are
not written guarantees.
OPERATING INSTRUCTIONS
O P E R A T I N G I N S T R U C T I O N S | WL24-2
en
13