Publicidad
Idiomas disponibles
Idiomas disponibles
Proper use
■
STEINEL mobile heat cordless hot air tools are intended for
shaping and welding plastic as well as for heating shrink
tubing. It is also suitable for soldering, tin-plating and un-
doing bonded joints.
■
The battery packs (18 V / 8.0 Ah) possibly included are
intended for use in Steinel cordless power tools with which
they are compatible. Only charge in genuine ProCORE
chargers. To select the correct tools, please contact your
retailer. Details can be found in the directions for use
provided with the charger and battery. The user alone is
responsible for any damage resulting from improper use.
Generally acknowledged regulations on the prevention
of accidents as well as the safety precautions must be
observed.
For your safety
The tool is equipped with overheat and overload protection
and multi-stage battery protection.
Tool features
➊
Stainless steel outlet nozzle
➋
Removable guard sleeve
❸
Setting wheel (9 temperature steps, 150 - 550°C)
❹
Status LED (reaching the set temperature, battery low
and errors)
❺
Air inlet
❻
Ergonomic soft grip
❼
Rechargeable battery release catch
❽
ProCORE rechargeable battery 8 Ah
❾
Rechargeable battery state-of-charge indicator
❿
Button for state-of-charge indicator
⓫
ON/OFF switch
Startup
Battery pack
Charge the battery pack
8
pack if performance drops. The ideal storage temperature is
between 10 °C and 30 °C. The permissible charging tempera-
ture is between 0 °C and 50 °C.
The rechargeable battery switches off at a temperature over
70 °C and remains switched off until it returns to the optimum
temperature range.
before use. Recharge the battery
"Li-Power, LiHD" li-ion battery packs have a capacity and sig-
nal indicator 9:
- Press button ❿ and the state of charge is indicated by the
LED lights (the power tool has to be switched off at least 1
sec).
- If an LED light flashes, the battery pack is almost drained
and needs to be recharged.
The tool's output capacity depends on the rechargeable
battery that is selected. To utilise the tool's full output
capacity, we recommend using genuine ProCORE battery with
the capability 8 Ah or higher.
Rechargeable battery state-of-charge indicator
The five green LEDs on the battery state-of-charge display
indicate the rechargeable battery's state of charge 9. It is
only recommended to check the state of charge when the
power tool has been switched off at least 1 sec or discon-
nected.
Press button
to display the state of charge (can also be
❿
done with the rechargeable battery removed).
The state-of-charge display goes out automatically after
approx. 3 seconds.
Inserting rechargeable battery
From the front, slide the charged battery 8 into the base of
the hot air tool. Push the rechargeable battery all the way into
the base until it clips into place.
Switching on the tool
Use the ON/OFF switch.
Removing, inserting battery pack
Removing: press button 7 to release the battery pack and
detach battery pack 8.
LED
Permanent light 5 × green
Permanent light 4 × green
Permanent light 3 × green
Permanent light 2 × green
Permanent light 1 × green
Flashing light 1 × green
If no LED lights up after pressing button ❿, the
rechargeable battery is faulty and must be replaced.
– 16 –
Capacity
≥ 4/5
≥ 3/5
≥ 2/5
≥ 1/5
< 1/5
Low battery
Publicidad
