+GF+ SPC D/PID Manual De Instrucciones página 41

Operating Instructions
7.2.3 Manually changing the process setpoint value
1. Setting the internal setpoint
2. Change process setpoint value manually
1 Return without change
2 Increase figure
3 Move one position to the left;
4 Apply set value
5 Changeable number
MENU Press for 3 s. Change from process level to setting level.
P.CONTROL selection. Selection in the main menu (MAIN).
ENTER selection. The sub-menu items for the basic setting are displayed.
SETUP selection.
ENTER selection. The menu for setting up the process controller is displayed.
SR-INPUT selection.
ENTER selection. The sub-menu items for the basic setting are displayed.
internal selection.
ENTER selection. The menu item has been enabled.
4x EXIT selection. Return to process level.
30.0
SP
SP
m3/min
MENU PV PV (t) INPUT
INPUT
SET VALUE
SP:
070.0
[m3/min]
+
+ <-
ESC
1 2 3
Use the arrow buttons to select the display for the process
setpoint value (SP).
Press the INPUT button.
Enter process setpoint value
70.0
5
OK
4
Type SPC D/PID positioner
41