Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
10.1
GENERAL INFORMATION
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety glasses.
10.2
CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth dipped in
neutral detergent.
•
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or excessive
grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
10.3
REPLACE THE SPOOL
1. Push the tabs (19) on the sides of the trimmer head at the
same time.
2. Pull and remove the spool cover (18).
IMPORTANT
IMPORTANT
IMPORTANT
18
19
20
21
22
English
3. Remove the remaining spool (20).
4. Put the new spool in the spool cover.
Make sure that the cutting line is in the slot on the new
spool, and is extended approximately 6" (15 cm) before you
install the new spool.
5. Put the ends of the cutting lines through the holes (21).
6. Extend the cutting line to release it from the guide slot in
the spool.
7. Install the spool and spool cover onto the trimmer head.
8. Push the spool cover until it clicks into position.
10.4
INSTALL THE CUTTING LINE
Do not put more than 13 feet of cutting line in at a time.
1. Remove the remaining cutting line on the spool.
2. Line up the slots on the spool cap with the slots on the
trimmer head.
10
NOTE
NOTE
Publicidad
