Adjusting the Height of the Left
Fridge Door
If the left door is lower, lift the left door, and turn
the hinge bolt using the spanner
drawing.
Adjusting the Height of the Right
Fridge Door
<Type1>
If the right door is lower, lift the right door, and
use the spanner
to turn the keeper nut
clockwise until the heights are balanced.
<Type2>
If the right door is lower, lift the right door, and
use a pair of long nose pliers to additionally
insert a snap ring until the heights are
balanced.
Connecting the Water Line
Water Supply Requirements
as in the
A cold water supply with water pressure
between 138 kPa and 827 kPa (1.4-8.4 kgf/cm²)
is required to operate the water dispenser. If the
refrigerator is installed in an area with low water
pressure (below 138 kPa), you can install a
booster pump to compensate for the low
pressure.
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs
to be a minimum of 138 kPa to 827 kPa
(1.4-8.4 kgf/cm²)
• Unplug the appliance before carrying out any
work on connecting the water line. Failure to
do so may cause electric shock.
• Only connect the water line to a cold water
supply. Failure to do so may cause the water
filter to malfunction. Water hammer (water
banging in the pipes) in house plumbing can
cause damage to appliance parts and can
lead to water leakage or flooding.
• Connecting the water line must only be
installed by a qualified plumber and in
accordance with local legislation and
regulations governing water quality.
NOTE
• This water line installation is not covered by
the appliance warranty.
WARNING
EN
17