SICK PowerProx WTT12L Instrucciones De Uso página 21

2 Safety information
2.1 Correct use
2.2 Qualification of personnel
8018110.1K5W/2023/07/10 | SICK
Subject to change without notice
Instructions to action
The arrow denotes instructions to action.
b
1. The sequence of instructions is numbered.
2. Follow the order in which the numbered instructions are given.
✓
The tick denotes the results of an action.
Connection, mounting and configuration of the product must only be car‐
ried out by qualified personnel.
This product does not constitute a safety component as defined in the
NO
Machinery Directive.
2006/42/EC
SAFETY
Do not install the product in places exposed to direct UV radiation (sun‐
light) or other weather conditions.
The product must be adequately protected against moisture and contami‐
nation.
Laser notes
CAUTION
Interference, manipulation or incorrect use can lead to hazardous exposure due to laser
radiation.
The emitted light beam must not be focused by means of additional optical devices.
LASER
1
Figure 1: Laser class 1
This device complies with the following standards:
• EN 60825-1:2014+A11:2021
• 21 CFR 1040.10 and 1040.11 except for tolerances according to Laser Notice No.
56 dated May 8, 2019.
The laser is eye-safe.
The laser marking is located on the housing imprint on the sensor.
The WTT12L is an opto-electronic photoelectric proximity sensor (referred to as "sensor"
in the following) for the optical, non-contact detection of objects. If the product is used
for any other purpose or modified in any way, any warranty claim against SICK AG shall
become void.
Any work on the product may only be carried out by personnel qualified and authorized
to do so.
OPERATING INSTRUCTIONS
O P E R A T I N G I N S T R U C T I O N S | PowerProx - WTT12L
en
21