Husqvarna Z560X Manual De Usuario página 24

9. Stop the engine.
10. Do a check of the hydraulic oil level and fill
hydraulic oil if it is necessary.
11. If it is necessary, do the above steps again until
all air has been removed from the hydrostatic
system. When the product operates correctly,
all air has been removed from the hydrostatic
system.
Lubrication, general information
• Remove the ignition key to prevent accidental
movements during lubrication.
• Clean the area before you lubricate a part on the
product.
• Use oil when you lubricate with an oil can.
• When you lubricate with grease, use a chassis
or ball bearing grease that prevents corrosion.
Remove unwanted grease after lubrication.
• Lubricate 2 times a week if you operate the
product daily.
• Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean
with alcohol. If the friction between the drive belt
and the pulley is not sufficient after you clean
with alcohol, replace the drive belt.
CAUTION:
other petroleum products to clean drive
belts.
Grease nipple
A B
A C
Refer to Lubrication
Lubricate the grease nipple on
A
the pivot axle with a grease gun.
Lubricate the grease nipple on
B
the wheel axle with a grease gun.
Lubricate the grease nipples on
C
each spindle with a grease gun.
Tightening torques
Engine crankshaft bolt
24
Do not use gasoline or
A A
A B
A C
A C
D D
Refer to Lubrication
Lubricate the grease nipple on
D
the cutting deck idler arm.
Always use good quality grease. Always use
recommended oil, refer to
28 .
To lubricate the front wheels
• Remove the dust cap (A). Grease the nipple (B)
with a grease gun until grease comes out from
the top washer.
A
C
• Lubricate the joint bearing of the front wheels (C)
with a grease gun until grease comes out.
To lubricate the cutting deck
spindles
1. Remove the footrest plate (A).
2. Lubricate the 3 cutting deck spindles (B) 2-3
strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
3. Lubricate the idler arm (C) 2-3 strokes.
50 ft-lb / 68 Nm
Technical data on page
B
A
C
B
2173 - 001 - 27.06.2023