Setup Settings (Setup); The Menu Points - WIKA CPC2000 Manual De Instrucciones

6. Commissioning, operation
6.5

SETUP settings (SETUP)

The SETUP menu items are made up of six submenus.
EN
RANGE: Setting of the pressure range (max. 100 % of the measuring span)
■
UNIT: Selection of the pressure unit (Pa, kPa, hPa, bar, mbar, psi, inH
■
Torr)
STEPS: Setting of the step size in x %. Settable in the range 1 ... 50 %
■
MODE: Selection of the operating mode
■
Control (CTRL): Regulates to the given set point
■
Measure (MEAS): Measurement of differential and relative pressure
■
Automatic (AUTO): Carries out a stored test routine
■
LANGUAGE: Selection of the displayed language
■
SETTINGS: Here additional instrument settings can be made
■

6.5.1 The menu points

1. With the MENU button and with the
is at the required menu point.
2. With the SELECT button, one reaches the desired submenu.
The following items are available in the submenu:
6.5.1.1 Range
Under the RANGE menu point the controller's final control value can be changed for the
control.
6.5.1.2 Unit
Here the unit, in which the low-pressure controller will display the measured value on the
screen, can be selected. Dependent upon the measuring range of the instrument, various
units are not available since they could not be displayed.
24
Navigation within the menu:
SELECT: Acts to confirm the relevant setting
Left/Right arrow: Setting of the active decimal point
Up/Down arrow: Change between the different submenu points.
/ button, press the up and down until one
WIKA operating instructions, model CPC2000
O, inHg, mmHg,
2