Publicidad
Idiomas disponibles
Idiomas disponibles
LUBRICATION & MAINTENANCE
1. Lubricate stapler prior to initial operation.
2. Disconnect the stapler from the air supply prior to
servicing.
3. Turn the stapler so that the inlet is facing up and put
one drop of high-speed spindle oil, UNOCOL RX22,
or 3-in-1 oil into air inlet. Never use detergent oil or
additives.
4. Operate the tool briefly after adding oil.
5. Wipe off excessive oil at the exhaust. Excessive
oil will damage the O-rings. If inline oiler is used,
manual lubrication through the air inlet is not
required on a daily basis.
Air Hose
Quick
Quick
Coupler
Connector
Figure 1
LOADING THE STAPLER
1. Disconnect the air supply.
2. Slightly squeeze the cover back, then pull top cover
open. (See Figure 2)
Figure 2
PAGE 2 OF 24
Quick
Oiler
Connector
Quick
Coupler
OPERATION
SETUP
AIR SUPPLY AND CONNECTIONS
Ensure air supply system is setup correctly for increased
the efficiency and life of the stapler. (See Figure 1)
Many air tool users find it convenient to use an inline
oiler to provide oil circulation through their tool. Check
oil level in the oiler daily.
NOTE: A filter is recommended on your air
compressor. Check the filter and drain on
a daily basis.
Filter
Regulator
3. Place coil staples in magazine. Feed front end of coil
staples into right coil guide, left coil guide and top
guide. Push forward until stopping in driver guide unit.
(See Figure 3)
4. Swing cover closed and squeeze to snap closed.
Check position engagement. (See Figure 3)
Figure 3
Compressor
0323 IH-1030
Publicidad
