Infrared-Remote Control - Cameo CLBARL10RGBIR/WH Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 62

INFRARED-REMOTE CONTROL:

Point the infrared remote control directly at the infrared sensor installed on the front of the
spotlight. The maximum range is about 8 metres. In the DMX and slave modes, the sensor on the
spotlight is disabled.
BL (Blackout) / ON/OFF
The BL button is used to switch off the spotlights, regardless of the mode selected on the remote control. Pressing
the BL button once more activates the previously selected mode again.
SP (SPEED)
10-level speed setting for the programs PG01 to PG12. First, press the SP button and then select the desired
speed using the + and - buttons. Level 1 makes the colour change sequence run slowly. Pressing again activates
level 2 with a faster colour change sequence, followed by levels 3 to 10, whereby level 10 represents the fastest
colour change sequence.
(BRIGHTNESS)
10-level brightness adjustment for the programs PG01 to PG12, the colour macros CM, the sound control mode
SC and the Auto mode AU. First, press the button
and then select the desired brightness level with the +
and - buttons.
FL (FLASH)
Stroboscope effect for the programs PG01 to PG12, the colour macros CM, the mode for colour mixing RGBWAU
and depending on the model, the Auto mode AU. After pressing the FL button, select the flash frequency (10
levels) using the + and - buttons. Level 1 represents the slowest (about 1 Hz) and level 10 the fastest flash
frequency (20 Hz).
R / G / B / W / A / U (red, green, blue, white, amber, UV) (depending on the model)
These 6 buttons can be used to create individual colour combinations. The 10 levels of brightness can be selected
by pressing the corresponding colour button, then using the + and - buttons, whereby, in level 1, the LEDs are
switched off.
For example: if you set red and green to their respective highest level and blue, white and UV to their lowest, i.e.,
off, the result will be a bright yellow colour mix.
PG (programs PG01 - PG12)
First, press the PG button and then select the desired program PG01 to PG12 using the + and - buttons. Select
the speed at which the programs are running, using the SP (speed) and + and - buttons.
CM (Colour Macros)
Colour presets that can be accessed using the CM and + and - buttons. The number of colour presets depends
on the model.
14

Publicidad

Tabla de contenido
loading

Tabla de contenido