Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
16
16
E
F
16
12
9
F
D
8.645-246.0
Manual Sensor Bp 12 36V Lithium
Kärcher Battery Power+ Units Mounting
and Removal
With the big release lever (16) on the backside of the
vacuum, the Battery Power+ Unit (9) will be unlocked
and pushed a small way out of its fixture.
It returns to working position after a Battery Power+
Unit has been installed correctly. Please observe the
relatively large weight of the Battery Power+ Units
when removing them! There is a risk of injury or fatal,
irreparable damage to the unit when falling down.
The Battery Power+ Unit should be removed from the
device with both hands and then be placed on a safe,
stable surface (e.g. table, workbench, etc.).
If work has been finished or battery is empty it can
directly be re-charged.
Replacing the Battery Power+ Unit works in reverse
order and should for your safety always be carried out
with both hands.
Please note that the Battery Power+ Unit has to be
inserted into your SENSOR Bp with contact side (E)
first. Otherwise it will not lock correctly into the fixture
and the device will not work.
If battery pack cannot be pushed-in correctly, check
that the internal guides are lined-up with guides (F) on
top of the battery
The display panel (D, Display) of the Battery Power+
Unit always has to stay visible. After Unit has been
inserted so far that tipping out is safely prevented,
push it further in with your flat hand on the front side
until the end position is indicated by a clearly audible
"Click".
Now the Battery Power+ Unit is positioned safely in
the device and as well the electrical contacts are
connected correctly.
At the same time, the release lever (16) automatically
returns to its operating position.
Publicidad
