Publicidad
Idiomas disponibles
Idiomas disponibles
14
15
11
12
16
20
24
2
1
6
2
25
6
8.645-246.0
Connecting and Operating Elements
10. Brush roller
11. Zipper
12. Sliders
13. Connecting device
15
14. Handle & Handle tube assembly
15. Handle guide
16. Battery release lever
20. On / Off-Switch
21. Height adjustment Brush
22. Brush cover right hand
23
23. Release button bearing block
22
24. Foot pedal
25. Filter bag connection
21
13
Assembly
Please Note: The dust bag housing cover cannot be
removed completely! It has not been shown in the
illustrations only to improve clarity!
Place the filter compartment (1) on the power head
(2) so that the connecting piece (13) reaches into the
corresponding opening. Open the zipper (11) of the
filter compartment by moving the two sliders (12) all
the way down to the right and to the left. Make sure
12
that both ends of the zipper reach straight into the
13
plastic part.
They may not be folded or protrude.
Then press the bottom plate of the filter housing with
the flat of your hand and shake it lightly.
For the final connection of the main assemblies one of
the M5x30 screws (6) from the screw bag (5) is used.
It should now be easy to push it a few millimeters into
14
the hole and then engage with the thread inserted
from the back.
15
The handle assembly (14) has to be inserted into the
guide (15) of the filter bag housing and will be
secured with the two remaining M5x30 screws (6).
Manual Sensor Bp 12 36V Lithium
Operation
9
Publicidad
