Publicidad
Idiomas disponibles
Idiomas disponibles
23
Step 4
34
33
34
1
6
2
8.645-246.0
22
Step 1
Step 2
10
Step 5
22
Step 3
35
33
1
2 3
Manual Sensor Bp 12 36V Lithium
Maintenance and Care
Before performing any maintenance or cleaning,
switch off unit and remove battery.
Removal of brush roller
In order to remove the brush roller of the power head
firmly press the button marked "PRESS" (23). Now
you can swing the bearing block (22) downwards and
remove it. Turn the brush roller (10) a bit clockwise
and pull it out. It has been proven good practice to
check the brush roller regularly for coiled yarn or hair
and remove them.
Removing Blockages
If only a slight suction effect is noticeable or if the
brush has been blocked, there may be a clog in the
air passage. On bottom of the power head, the cover
(33) of the air duct can be opened by releasing latch
(34) in order to remove clog from the air channel.
Make sure that there is no clog beneath this cover or
in the transitions to brush channel and turbine.
When everything has been cleared, swing back cover
until the latch snaps into its counterpart (35).
If you suspect a blockage in the filter compartment
(please refer to page 9), remove battery, remove
screw (6) and separate power head (2) and filter
compartment (1). The air channel in the filter compart-
ment can be checked easily from bottom.
Do not try to open air channel in filter compartment!
If latches break, machine will not work correctly any
longer.
Under no circumstances blockages or clog may be
cleaned by means of sticks or other hard or solid
tools. Damages would be very likely.
Filter bag cover not shown
Maintenance
13
Publicidad
