Publicidad
Idiomas disponibles
Idiomas disponibles
06 Lighting / °C °F (3 sec)
Lighting
°C °F
07 Water / Filter Reset (3 sec)
Water
Filter Reset
TBI_Dacor_UserManual_DA68-03581B-00_EN.indd 23
By default, the dispenser lamp turns on only when the dispenser is
used. If you want to keep the dispenser lamp turned on (continuous
mode), press Lighting. The lighting indicator also turns on. To restore
the default settings, press Lighting again.
You can use the Lighting button to switch the temperature scale
between Celsius and Fahrenheit.
To switch the temperature scale, press and hold Lighting for 3 seconds.
Press Water to dispense water. In this mode, no ice will be dispensed.
After about 6 months of using the original water filter (which typically
amounts to about 320 gallons (1200 liters) of water), the Filter
indicator blinks red to remind you that the filter needs to be replaced.
When this happens, replace the filter, and then press and hold Water
for 3 seconds. This resets the filter lifecycle detector and turns off the
Filter indicator.
NOTE
• Some areas have relatively large amounts of lime in their water.
This may reduce the lifecycle of the filter. In these areas, you will
have to replace the water filter more often than specified above.
• If water is not dispensing properly, the water filter is most likely
clogged. Even if the Filter indicator is not blinking, replace the
water filter.
English 23
2022-11-18
5:56:15
Publicidad
